Mold on an LG Washer Door Seal? What to Look For
By Eyal Malka, owner of Vent Pro NYC · 12 years in the trade
Published · Reviewed · 4 min read
“My LG has black spots on the door seal” is how a lot of our calls start. LG is one of the two front-loader brands we see most in Brooklyn, so we have pulled back a lot of LG door seals. There is nothing special about the rubber on an LG: it molds for the same reasons as every other front-loader, and our LG & Samsung guide explains why. This page is about what you are looking at, and where.
Where to look, around the ring
Open the door and work your way around the rubber seal like a clock, folding the lip back toward you as you go.
- The bottom (around 6 o’clock). Water runs down and collects here after every load, so this is where mold usually starts and where it is heaviest.
- The channel under the fold. The groove you only see with the lip pulled back. A dark ring, grey slime, hair, or lint in here has been growing a while.
- The face that touches the glass. Spots here are the easy ones, visible with the door open and usually the lightest case.
- The top half. It dries faster, so it usually has less. If the top is as dark as the bottom, the seal has been wet for a long time.

Mold, stain, or a damaged seal?
Wipe a dark patch with a damp paper towel. If black comes off, or it feels slimy, that is mold growing on the rubber, and it can be cleaned out. If the towel stays clean and the mark is flat, it is staining in the rubber, which usually only fades. A tear or hole in the inner fold, rubber gone hard and cracked, or a leak is different: that seal needs replacing by an appliance repair technician, not cleaning. How to tell.
What about Tub Clean?
LG front-loaders have a tub-clean cycle, and the manual is right to tell you to run it. It flushes the drum, not the folds of the seal, so mold that is already under the lip survives it. Why the cycle misses it.
What fixes it
Spots on the face of the rubber are a DIY job: our DIY guide walks through it. A ring deep in the channel, or mold that keeps coming back, is the job we do. Our washer gasket mold removal in Brooklyn is $179.99 flat for an LG or any other front-load washer: our four-step treatment on every fold of the washer door gasket, with the drain filter cleaned in the same visit. Afterward, the 20-second habit keeps it from starting over.
