What Happens at a Washer Gasket Cleaning Visit
By Eyal Malka, owner of Vent Pro NYC · 12 years in the trade
Published · Reviewed · 5 min read
You booked because of a smell and a black ring, and now someone is coming to work in your laundry room for half an hour. It is fair to want to know exactly what they will do. This is the whole visit from Vent Pro NYC, the family-owned Brooklyn company behind this site, in the order it happens. The only thing we leave out is what is in our solutions.
Before we arrive
Make sure the washer is empty and that we can reach it. We bring everything else and work clean. Stacked pairs and tight laundry closets are normal for us, and we do not charge extra for a machine that is hard to get at. If you book online, a $50 deposit holds the slot and comes off the bill.
First, we look
Before anything is sprayed, we pull the rubber lip back and work around the whole ring, checking the rubber itself and what is sitting in the channel underneath. If the seal is torn, split, or has gone hard, a cleaning will not hold. We tell you on the spot and point you to an appliance repair technician we trust instead of charging for it. Here is how to tell the two cases apart.
The four-step treatment
The sprays are our own solutions — mixed in-house, refined job after job, and chosen to draw as much mold as possible out of the rubber without cracking, drying, or otherwise damaging the seal. What's in them stays our secret; what they do is the point.
- First solution, scrubbed in. We spray the gasket with the first of our in-house solutions and work it into every fold with a scrub brush, then dry the rubber down.
- Second solution, dried again. A second solution goes over the whole seal to keep breaking down what the scrub loosened — then we dry the gasket down again.
- Third finishing formula. Our third formula treats the clean rubber so the seal isn't just mold-free when we pack up — it's a much harder place for mold to move back into.
- Mold-stain remover gel. Wherever staining still shows on the rubber, we coat it with mold-stain remover gel and leave it on to keep working after the visit.



The drain filter
The visit includes the washer’s drain (pump) filter: the trap behind the small access door at the bottom of the machine, where coins, lint, and sludge collect. We remove it, clean it, and refit it. Why that filter matters is in our drain filter guide.
What we don’t touch
The scope is the visible rubber of the door seal, plus the drain filter. We don’t go behind the gasket or inside the drum, we don’t open up the machine, and we don’t service top-loaders.
Your one step: the aftercare bag
On the way out we leave you an aftercare bag: printed instructions, a glove, a cloth, and the machine-cleaning tablet that tested best for us. About 90 minutes after the gel goes on, put on the glove and wipe all the gel off the rubber with the cloth (lightly dampen it if needed), then drop the tablet in the empty drum — no clothes, no detergent — and run the machine's tub-clean cycle. Once that cycle finishes, the washer is ready for regular laundry.
How long it takes, and what it costs
About 30 minutes for a standard front-load washer. The visit is $179.99 flat, drain filter included, plus a flat $50 travel charge for addresses more than 3 miles from our Brooklyn shop ($229.99 there), whether or not you add a dryer vent cleaning to the same visit. The booking page shows your exact total before you pay. The full breakdown is in our pricing guide, Manhattan’s days and hours are in the Manhattan guide, and how to keep the seal clean afterward is in how often to clean a washer gasket.
