WasherGasketMold.coma Vent Pro NYC service
All guides

Samsung Front-Load Washer Smells Musty? Check These 3 Spots

By , owner of Vent Pro NYC · 12 years in the trade

Published · Reviewed · 4 min read

“My Samsung smells musty no matter what I do” is one of the most common things we hear. Samsung is one of the two front-loader brands we see most in Brooklyn laundry rooms, so we have looked inside a lot of them. The short version: nothing is wrong with your machine, and there is no Samsung secret. The smell almost always lives in one of three spots, and you can check all three in about ten minutes.

Spot 1: the rubber door seal

Start here, because it is the most common source. Open the door and fold the rubber lip back toward you, all the way around, starting at the bottom where water collects. A dark ring, grey slime, hair and lint, or standing water in the channel means you have found it. Put your nose near the fold: if the smell is strongest there, you can stop looking.

Why the seal on a high-efficiency front-loader molds at all, on Samsung and every other brand, is in our LG & Samsung guide.

Spot 2: the detergent drawer and its housing

Pull the detergent drawer all the way out (your manual shows the release), then shine a light into the housing it slides into. Water and residue sit in there after every wash. Dark buildup on the drawer or on the walls of the housing can smell musty too. How to check the drawer.

Spot 3: the drain pump filter

Behind a small panel near the bottom front of most front-loaders is a filter that sits in standing water and catches lint, hair, and coins. Your manual shows where it is on your model. Put a shallow pan and a towel down before you open it. Our drain filter guide walks through it.

A drill-driven brush scrubbing foaming cleaning solution around the door gasket of a front-load washer, the drum visible through the open door
Our own photo, from a gasket visit: scrubbing every fold of the seal. A mold ring under the fold has to be cleaned by hand.

What the manual already tells you

The care section of the manual gives the same advice we leave at every visit: wipe the door seal, leave the door ajar between loads, run the tub-clean cycle regularly, and measure HE detergent. Those habits are what keep a clean seal clean; here is the 20-second version.

When to call us

Light spotting on the rubber door seal is a DIY job, covered in our DIY guide. If the mold is deep in the folds or keeps coming back, our washer gasket mold removal in Brooklyn is $179.99 flat for any brand of front-load washer: our four-step treatment on every fold of the seal and the drain filter cleaned in the same visit, with the detergent drawer and its housing as a $29.99 add-on. We treat mold and staining. When the seal is the source, the smell often eases with it, but we don’t promise it is gone for good (the sewer line it drains into can smell too), and the black staining usually only fades.

Share this guide